Twisted Leaf Yucca

Keep the root area slightly damp until a new plant roots in, then stretch the time between waterings. Once rooted, soak it deeply about every 2 to 4 weeks in summer, less in spring and fall, and little or none in winter. Let the soil dry between soakings.

Plant it at the same depth it grew and keep the same side facing south. Shade a new plant with shade cloth until new growth shows, and skip the fertilizer, since it does not need any.

Old leaves fold down into a shaggy skirt, and removing them is optional. Cut each spent flower stalk low after it finishes. It blooms again in later years.

Snout weevils are the pest to watch for on yuccas. Leaves wilt or lean, the base goes soft, and the plant collapses. Good drainage and little water once rooted keep it healthy. Remove a collapsed plant and the soil around it so grubs do not spread.

It is rated to about -10°F. Keep the soil on the dry side in winter, since wet, cool soil leads to rot.

Drainage test first. Dig the hole and fill it with water. If water is still sitting in the hole a day later, you likely hit caliche, clay or hard soil, so fix the drainage before planting. If it drains very fast, the soil is sandy. Standing water around roots is a common reason new plants fail.

Weed cloth. Cut it away from the planting hole and where the roots will spread. Remove any plastic sheeting completely, since it keeps water and air out of the soil.

Rock or decomposed granite with no soil underneath. Bring in soil close in texture to your native soil, mix it with the soil below, and build up enough depth for roots before planting.

If you can break through. Use a breaker bar, pick, or jackhammer. Dig through the caliche and break out the solid chunks. Backfill with the soil you dug out, with no compost or manure in the hole. Confirm drainage before planting.

If you cannot break through. Dig narrow holes through the hard layer beside the root ball, not under it, and refill them with the same soil, not gravel. If it still will not drain, plant on a low mound of the same soil.

Root ball. Check the outside edges for any roots circling around. Loosen or cut those so they grow outward. Do not break up the center of the root ball.

Depth. The top of the root ball should sit at or just slightly above the surrounding soil level. Planting too deep can lead to rot and kill the plant.

Drip emitters. At planting, put the emitters on the root ball, on different sides of the plant. After about 2 months, move them to the outer edge of the root ball. Over the first year, add emitters farther out toward the edge of the branches as roots grow. Once a plant is rooted, never water only at the trunk.